Ferroli bluesense 54/10/2023 9 The OpenTherm extension is a separate module. 8 The terminals -10 and +10 are located on the expansion A8 in the boiler. 7 Turn the D20 funtion to OpenTherm (when used as OpenTherm thermostat). ![]() 6 Place the supplied resistor 1,5kΩ, 1W between clamps 2 and 4. 5 The OpenTherm module is available separately. 4 Connect the thermostat to the green terminal block. 3 OTM 4 can be ordered from the manufacturer. 2 Devices from before May 2003 may have other connections. on/off, Ebus) Probably not suitable the operation is currently being investigated Unknown the operation is currently being investigated 1 Terminal block / plug on the bottom of the boiler. Legend Symbol OpenTherm protocol Probably suitable the operation is currently being investigated Is not supported uses another protocol (e.g. We will process this information so the list stays up to date. ![]() Is your boiler not on the list, or does the status differ from what we describe below. This means that both the thermostat and the boiler must support OpenTherm. The boiler gateway communicates with the heating system via the OpenTherm protocol. ![]() 1 Boilers The following list shows which boilers work with Qupit boiler gateway Adam.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |